Strong Foundations. Superior Results.
Precision air sealing that stops the drafts driving up your energy bills and chilling PNW homes.
Maybe the house is drafty in winter, the heat runs often, or one room never seems to hold its temperature. Those are the usual reasons homeowners in Milton start looking at air sealing.
Air sealing closes the gaps where indoor air leaks out and outdoor air leaks in, mostly in the attic and floors. Washington Construction gives free estimates, so you can have the leaks looked at before you decide anything. Utility rebates may also apply, depending on your utility and your home.
Warm air rises. In winter it pushes up through small openings in the ceiling and pulls cold air in lower down. Common leak points are gaps around wiring and plumbing that pass through the attic floor, recessed lights, the tops of interior walls, and attic hatches. Air sealing closes these gaps with sealant, foam or other materials suited to each opening.
Age matters here. About 35% of housing units in Milton were built before 1980, per Census ACS 2020-2024 data, and that figure includes apartments. Older framing often has more gaps and less insulation. That is a general pattern, not a statement about any one house. An inspection of your attic will show what yours actually has.
Heating type matters too. The Census shows about 65% of Milton homes heat with electricity and 32% with utility gas. If you heat electrically, leaks show up directly in your power use. Electric service in Milton is split among City of Milton Electric, which is primary, Puget Sound Energy and Tacoma Power. Gas comes from Puget Sound Energy. Your utility decides which rebates you may qualify for, so check your bill first.
Rebates were checked November 1, 2026, and they change. Puget Sound Energy lists an attic air sealing rebate of $0.20 per sq ft, up to $400 per area, for site-built homes built in 1989 or earlier. The attic must be unsealed before the work and sealed to PSE weatherization specs after, and PSE must be the primary space heat. Tacoma Power lists attic insulation rebates for customers with electric primary heat and existing attic insulation of R-11 or less, with a target of R-49 plus air sealing. PSE also lists attic insulation rebates tied to the existing insulation level.
Rebates usually require the utility's participating contractor. Confirm your eligibility with the utility before work begins, so you do not lose a rebate by starting too early. Also note that PSE does not allow removing existing insulation just to qualify.
The work itself is mostly done in the attic. The crew finds and seals the gaps, and insulation is often added afterward, since sealing first helps insulation perform as intended. A free estimate is a practical way to see which steps fit your home.
A small city on the King and Pierce county line between Federal Way and Fife.
Cuts conditioned air loss through hidden gaps; Balances room-to-room temperatures; Keeps humid outdoor air from entering wall cavities; Improves the performance of any insulation upgrade; Lowers strain on heating and cooling equipment