Strong Foundations. Superior Results.
We install smart thermostats that trim heating costs through Washington’s long, damp heating season.
Smart thermostat installation makes the most sense just before the heating season starts, in early fall, or at the start of a cold snap you can plan around. That is when you will notice right away whether the schedules and sensors suit your household. A system that is down for a few hours is also easier to live with in mild weather.
In Mercer Island, the Census reports that 38% of homes heat with electricity and 58% with utility gas. That split matters here, because the type of heating system decides which thermostat will work and how it gets wired.
Before you pick a thermostat, find out what it will control. A gas furnace, an electric furnace, a heat pump and electric baseboard heaters are all wired differently. Line-voltage baseboard heaters, for example, need a thermostat made for that voltage. A low-voltage model will not work on them. Census data shows 38% of Mercer Island homes heat with electricity and 58% with utility gas, so both setups are common here.
Age of the home is one factor. About 61% of Mercer Island housing units were built before 1980, per the Census ACS 2020-2024, and that figure includes apartments. It does not tell you about your house. But if your home is older, the existing thermostat wiring may be thin, worn or missing a common wire. Many smart thermostats need that wire for steady power. If it is missing, the job may involve running new low-voltage cable or adding an adapter.
Other things that change the work:
The number of heating zones, whether you have cooling, and where the old thermostat sits relative to the equipment. Compatibility with the furnace or heat pump control board also matters.
The work starts with checking the existing wiring and the equipment it connects to. Power to the system is shut off during the swap. The new thermostat is then mounted, wired, set up on your Wi-Fi and tested against the heating system. Electrical, plumbing and HVAC work at Washington Construction is done by our own crews, not subcontracted, so the person who checks the wiring is on our team. Labor carries a 1-year warranty.
Take a clear photo of the wires on your current thermostat, with the labels visible, before the visit. It helps confirm early whether a common wire is present and which thermostat models will fit.
An island city in Lake Washington connected by I-90 between Seattle and Bellevue.
Lower energy bills through learning schedules and remote control; consistent comfort tuned to your daily routine; safe, code-compliant wiring and mounting; app-based control from anywhere; compatibility verified with your existing HVAC