Strong Foundations. Superior Results.
Hanging, taping, and finishing drywall to give garage walls and ceilings a clean, fire-rated surface.
Your garage walls are bare studs, or the drywall is cracked, dented, stained or peeling at the seams. Maybe you want a finished space for storage, a workbench or a place to park without looking at insulation and framing. Garage drywall gives the room clean, flat walls and a ceiling you can paint and keep up.
Washington Construction, based in Bothell, WA, hangs, tapes and finishes garage drywall for Lynnwood homeowners. This page explains what drives the work here, what local conditions mean for your walls, and what to expect once the job starts.
Garage drywall usually needs work for a few plain reasons. Cars, bikes and shelving knock into walls. Moisture gets in through doors, slabs or small leaks and leaves stains, soft spots or peeling tape. Older garages may never have been finished at all, or were patched many times over the years.
Local conditions matter here. Lynnwood sees about 104 days a year with 0.1 inch or more of rain, based on Daymet data for 2005 to 2025. Wet weather means damp air and water tracked into the garage. Drywall in that setting does best when moisture sources are found and fixed before new board goes up. Otherwise stains and mold can return under fresh paint.
Age of the housing stock also shapes the job. About 53% of housing units in Lynnwood were built before 1980, per the Census ACS 2020-2024, and that figure includes apartments. Homes from that era can have older wall materials, and homes built before 1978 may have lead paint on existing surfaces. If your garage is in an older house, the old finishes should be checked before sanding or cutting. About 24% of units were built from 1990 to 2009, so they are now 15 to 35 years old. In those garages the common issues are settled seams, nail pops and dings from years of use.
The work itself follows a set order. First, the crew looks over the framing and any damaged board and notes moisture problems. Damaged sections come out. New sheets are cut and screwed to the studs, then seams get tape and joint compound. Compound is applied in coats and sanded between them, so the surface comes out smooth. Priming and painting come last if they are part of your plan.
Washington Construction gives a 1-year warranty on labor for this work. That covers the workmanship, so ask about the details when you plan the job.
A commercial and residential hub in southwest Snohomish County near I-5 and I-405.
Provides code-required fire separation; Creates a smooth, paintable surface; Uses moisture-resistant board where needed; Upgrades the look and safety of the garage