Strong Foundations. Superior Results.
An LED lighting retrofit that slashes electricity use while brightening every room.
Is an LED lighting retrofit worth doing in a Stanwood home? Usually it is a practical upgrade, because LED fixtures and bulbs draw less power than the older lighting they replace and give off less heat. The work ranges from swapping bulbs to replacing fixtures or adding recessed lights.
This page explains what to check before you start, based on Stanwood's housing and utility details. Washington Construction gives free estimates, so you can have the scope of your own home looked at before you decide on anything.
About 18% of Stanwood housing units were built before 1980, per the Census ACS 2020-2024. That figure includes apartments, so it says little about any one house. Still, if yours is from that era, the existing fixtures and wiring deserve a look before you swap them. Older ceiling boxes, dimmer switches and fixture wiring do not always suit modern LED drivers. Dimmers are the usual trouble spot, since some older ones cause flicker or buzzing with LEDs. Checking this early keeps the retrofit from turning into repeat visits.
Snohomish County PUD is the electric utility in Stanwood. Utilities sometimes offer incentives for efficiency work, so ask the PUD directly what applies to lighting before you buy fixtures. The rebates we have on record from the PUD and from Cascade Natural Gas, checked November 1, 2026, are for attic insulation and insulation bundles. None of them are for lighting, so do not count on them to cover an LED project. Those programs usually require the utility's participating contractor, and you should confirm eligibility with the utility yourself.
In Stanwood, 41% of homes are heated with electricity and 56% with utility gas, per the Census. Standard practice says older incandescent bulbs put out a lot of heat. In a home with electric heat, much of that heat was doing a small amount of useful work in cold months. In a gas-heated home, the lighting savings come mostly from the lower wattage. Either way, the main gain is lower power use for the same light. It helps to know which heating setup you have when deciding which rooms to start with.
If you are also thinking about attic insulation, mention it when you ask for an estimate. Ceiling and attic work can be easier to plan alongside recessed lighting changes, since both involve the same ceiling space.
A city near the mouth of the Stillaguamish River in northwest Snohomish County, near farmland and the coast.
Cuts lighting energy use dramatically; Lasts far longer than incandescent or halogen; Improves light quality through dark PNW winters; Reduces heat output from fixtures; Adds dimming and control flexibility