Strong Foundations. Superior Results.
We install the supply, drain, waste, and vent lines behind your walls before insulation and drywall go up on a remodel or addition.
This page is for Mill Creek homeowners who are framing a new addition, finishing a basement, adding a bathroom or laundry, or opening walls in a remodel. Rough-in plumbing is the stage where supply lines, drains and vents are set inside the framing, before drywall covers them.
Washington Construction is based in Bothell, WA, and plumbing is done by our own crews, not subcontracted. That means one team handles the rough-in and the work around it. Below, we compare the main ways to approach the job and what Mill Creek conditions favor each.
Most rough-in jobs come down to a choice between two approaches. You can run new lines to a new space, or you can reroute and replace existing lines while the walls are open. Each fits different homes.
This suits a new bathroom, a basement finish or an added laundry. The work is laid out around the framing, so you can plan fixture spots, drain slopes and vent paths before anything is closed up. Decisions made here are hard to change later, so settle your fixture list first.
This suits a remodel where walls are already open. Per the Census ACS 2020-2024, about 15% of housing units in Mill Creek were built before 1980, and that figure includes apartments. That is a small share, so many Mill Creek houses will have newer piping. Still, if your home is older, open walls are a good time to have the existing lines checked and to decide whether to replace what you can see.
Daymet data shows about 35 days a year in Mill Creek when temperatures freeze at night and thaw by day. Water lines in exterior walls, crawl spaces and garages are the ones exposed to that cycle. When you can choose, keep supply lines on the warm side of the insulation. This is standard practice and worth raising during layout.
The Census reports that 57% of Mill Creek homes are heated mainly with utility gas. If you are adding a gas-fired water heater or appliance, ask that its location be planned during rough-in, so the plumbing and any gas runs do not compete for the same wall space.
Our labor carries a 1-year warranty, and the same crews that rough in the plumbing stay involved through the stages around it.
A planned residential city in southwest Snohomish County built around a town center.
Fixtures that drain and vent correctly the first time; work sequenced to pass Washington rough-in inspection without delays; pressure-tested lines that reveal hidden defects before they are concealed; layout coordinated with framing and electrical to avoid conflicts; a documented foundation for your future finish plumbing