Strong Foundations. Superior Results.
Trim painting sharpens the baseboards, casings, crown, and doors that frame every room.
You notice it first on the window trim or along the fascia. The paint is chalking, peeling at the corners, or cracking where boards meet. Trim takes more weather than almost any other part of a house, and it shows wear early.
This page explains what drives that wear in Lyman, what the weather means for timing, and how trim painting is done. Washington Construction, based in Bothell, WA, has been in business for 22 years.
Paint on trim fails for a few plain reasons. Water gets behind the film at end grain, joints and sills. Sun breaks down the surface. Wood swells and shrinks, and the paint cracks along with it. Once the coating opens up, moisture reaches bare wood and the damage spreads.
Rain is the main factor in Lyman. Daymet data for 2005 to 2025 shows about 134 days a year with 0.1 in or more of rain. That is a lot of wet days for trim to dry out between. Joints, window sills and the lower edges of boards stay damp longer, so a small gap in the paint matters more here than it would in a drier place.
The same numbers help with planning. July is the driest month in Lyman on average. Exterior paint needs dry surfaces and dry days to cure, so summer is the easier window for outside trim. Other months can work, but you should expect to wait for a break in the weather, and the schedule may shift around it.
Lyman is a small town of about 176 homes. That is too few for reliable Census percentages, so there is no useful local figure for the age of houses. Age still matters on your own home. If it was built before 1978, the old paint may contain lead, and sanding or scraping it calls for extra care. It is worth knowing before any prep begins.
Good trim painting is mostly preparation. The old paint is scraped and sanded back to a sound edge. Loose or failed paint is removed, not covered. Soft or rotted wood is found and flagged, because paint will not hold on it. Bare spots are primed. Gaps at joints are caulked where that is appropriate, so water has less room to get in.
Then the finish coats go on. Each coat needs time to dry before the next, and that is where wet weather slows things down. Edges, corners and the bottoms of boards get attention, since those are where paint usually fails first.
If you are seeing peeling or bare wood now, it helps to deal with it before the next wet season. Painting sound trim is simpler than repairing trim that has absorbed water for a year or two.
A very small town along the Skagit River in rural eastern Skagit County.
Durable enamel finish that resists scuffs and repeated cleaning; hand-caulked seams for a seamless, gap-free look; smooth surfaces from careful sanding and hole filling; crisp lines where trim meets walls and ceilings; a refreshed look for baseboards, casings, and crown molding